WELCOME TO VISIT YANCHENG GREATER MACHINERY CO.,LTDOFFICIAL WEBSITE!

About us

联系我们

YANCHENG GREATER MACHINERY CO.,LTD
add : 8 fenhuang road dagang town , yancheng City , jiangsu province , china
TEL:0086-515-88802888 88803999
FAX:0086-515-88853199
Mob:86-13962062659 13805101949

News detail

Your current position: Home >> News >> News detail

Setting of cutter height of cutting machine

Release date:2017/11/20 23:27:35 Views: 137Secondary
1, remove the debris on the working surface of the board, will be placed in the center of the plastic mold; 2, the machine starts, will set the handwheel release, the pressure system to zero; 3, set the switch to the right to the "knife mold set" direction, cutting plate 13 that began to slow down to close the knife die will automatically stop; 4. Set the handwheel to the bottom and tighten it. Set the switch system (left) to the "cut" position before starting 04; 5, and then press the brake switch, the cutting plate on the immediate recovery to the highest position, at this time the knife mold set is completed. Adjustment of cutting points of semi automatic precision four column cutting machine 1, setting of the knife mold work is completed, will be laid on the material on the plate, then put in the knife mold materials, and then promote the feed plate cutting area; 2, respectively, with both hands pressed 12 cutting switch, at this time decreased pressure on the cutting platen die cutter, cutter to cut off the material automatically after back to the position before starting to stop; 3, in the blanking material, such as material found not completely cutting when the cutting depth of 03 to adjust the controller, the "pressure system" to counter clockwise direction of rotation; such as knife rubber molded into too deep, will be "pressure system" to the counter clockwise rotation, adjustment of the longer the cutting depth is deeper, try to to adjust the cutter slightly pressed into the sheet so far; 4, the material will be pulled out of the cutting area, take out the material, in order to complete a blanking process.